Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Parasound HCA-1000 problem posted by Cuernavaca on November 6, 2015 at 07:38:22:
I saw a small amount of leakage around the power supply caps, removed the board and saw some major damage to the board, 3 of the 4 caps had leaked and there was a hole right through the board. I had to repair 2 traces, removed the toasted parts and installed new caps. It started right up, no hum and after 30 minutes I adjusted bias. I had wanted to increase the bias(on recommendation from John Curl), at the 10 mv recommendation from Parasound, the heatsinks don't even get lukewarm. One side was easily adjustable, and I increased it to 18mv. The other channel won't adjust past 11mv. Not sure if it's a bad trim pot or bias resistor. In any case, it sounds just fine.
Thomas
"I've never owned a firearm, but I do have an attack parrot!"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Power supply caps, not relay - Cuernavaca 11/14/1517:05:43 11/14/15 (1)
- RE: Power supply caps, not relay - fantja 18:22:47 11/14/15 (0)