Home Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Re: Planning to do the same to my pair of Hafler DH-200s. No use guilding the lily there!!! nt

In addition to replacing the input and output connectors, I also:
Replaced the stock power cord with a Furutech IEC inlet.
Replaced all of the electrolytic caps.
Replaced the transistors and diodes on the output protection circuit board.
Did a couple of performance-improving mods to the output protection circuit recommended by the folks at DIY Audio.
Fixed one non-working meter.
Added power resistors to slow down the cooling fan and lessen noise (with the fan disconnected, during normal listening the heatsinks never get more than faintly warm).
Adjusted the DC offset.
Cleaned up the boards, chassis and removed rust spots.





This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.