Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

If you want to get rid of the fuses...

...may I suggest a better way? Rather than bypass, you can actually eliminate them, their wiring, and the attenuators/jumpers in one fell swoop. It's a simple process too, will cost you nothing, and only take a few minutes. In the image below you will see that there is a yellow and a red wire above with a blue wire on the lower right. Take off the back plate (just four screws). Remove the nut for the yellow wire and remove the wire that leads to the fuse - don't remove the yellow wire. Then remove the nut for the blue wire and move that wire onto the connector with the yellow wire and put the nut back on it. Put the back plate back on your MMGs and you're done!




"Jazz is not dead - it just smells funny" FZ


This post is made possible by the generous support of people like you and our sponsors:
  McShane Design  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.