|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
|
|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
In Reply to: Re: Need help for soldering.... posted by JimL on March 13, 2005 at 17:36:38:
I've never used a solder pot but I have the technique down using a hot soldering iron. The iron doesn't need to be 800 degrees, but 750 sure helps. You hold the tip of the iron against the end of the wire because there's no enamel insulation on the end. Wait a few seconds for the wire to heat, then apply solder. You'll see the enamel bubbling off and you can then "walk" the iron and solder up the wire until you have enough enamel melted off for your needs. The wire will be perfectly tinned. This method uses up quite a bit of solder.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Let me expand on that. - Grover 03/13/0519:06:47 03/13/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
